ATS (mains-gen) 3 ph.100A

ATS Panels/Cables

3 PHASE ULTRA COMPACT AUTOMATIC TRANSFER SWITCH CONTROL PANEL (250x350x150mm)
Current rating: 100 Amp.

Working voltage 220~240Vac (L~N) @ 45~65Hz

Description
This Automatic Transfer Switch (ATS) control panel is designed to sense when an electric utility outage occurs. If it happens, the ATS tells the backup generator to start. Once the ATS sees that the generator is ready to provide electric power, the ATS breaks the home's connection to the electric utility and connects the generator to the home's main electrical panel. The generator supplies power to the home's electric load, but is not connected to the electric utility.

When utility power returns for a set time, the transfer switch will transfer back to utility power and command the generator to turn off.

Specification

Designed for 3 phase + neutral power supply.
IP65 wall mountable ATS panel
Earth stud on back plate.
Enclosure made from ABS lockable plastic enclosure.
Colour: RAL7032 Light grey.
100A Unit supplied with mains phase failure / genset available monitors and Auto Start function.
Mains & GenSet Available LEDs.
Mains & GenSet On Load LEDs.
Excellent quality control gear used.
Very easy to use and install.
2x Programmable timers on board:

1# GenSet on load delay time (0.1sec~10days adjustable). Default delay time: 10sec.

2# Mains on load delay time (0.1sec~10days adjustable). Default delay time: 10sec.

Adjustable protective mains power relay on-board: over/under voltage protection, phase failure and phase sequence protection.

The auto start output is protected by F1 2A quick blow fuse.

The mains contactor coil is protected by F2 2A quick blow fuse.

The GenSet contactor coil is protected by F3 2A quick blow fuse.

Manual / Auto change-over switch mode available.

Delivery is made via FedEx courier (UK) usually within 1-2 working days.

ATS Wiring Diagram